How to Pair Your AirPods (Gen 1, 2,3) and AirPods Pro (Gen 1 & 2) Replacement Parts   Put your AirPods in their charging case and connect them to a  power source for 1 hour.  Delete your old bluetooth listing found in your bluetooth settings. Open the lid of your charging case. With the lid open, press and hold the setup button on the back of the case for about 15 seconds until the status light flashes amber quickly 3 times, then white.* Reconnect your AirPods: With your AirPods in their charging case and the lid open, place your AirPods close to your mobile device and follow the steps on your device's screen. After you've followed these steps, your AirPods will now be synced together. If you've followed these steps and still see a blinking amber light when pairing, leave the AirPods in the charging case for 60 minutes connected to power, and then repeat the above steps. We always recommend that the device you are pairing to is connected to WIFI. If the Airpods are still not connecting together, please follow the steps below to perform a firmware update. How to Pair Your AirPods Generation 4 (ANC & NON-ANC Model)   Put your AirPods in their charging case and connect them to a  power source for 1 hour.  Delete your old Bluetooth listing found in your Bluetooth settings. Remove the charging cable and open the lid of your charging case. Double-tap the front of the case while the status light is on. Double-tap again when the status light flashes white. Double-tap a third time when the status light flashes faster. When the status light flashes amber then flashes white, you can then reconnect your Airpods with the setup animation.           AirPods Pro (1st Generation) / (2nd Generation)   AirPods (3rd Generation)   AirPods (2nd Generation) Firmware Updates In some cases, you may need to have the AirPods update their firmware. This update can take as little as 1 hour, up to 8 hours. For best results, we recommend following these steps overnight.   Here are