TEMCo Industrial Market Share Analysis for January 2026

Product Description Specifications Warranty Info 16 Standard Sizes in AWG Conforms to DIN industrial terminal size standard. Compatible with all US domestic market terminals, including color coded lugs. True-Hex Crimp Applies even pressure on all sides creating sharp edges and high pullout resistance. Half Sizes Proprietary half size dies accommodate hard-to-fit non-standard lug types. Dies Imprint AWG Size Imprints die size into crimped terminal for code compliance inspections.* *Only on AWG sizes, not available in AWG+ How to Use: Step 1 Install the die set that matches your terminal size. Step 2 Close the release valve by rotating to the right (clockwise). Step 3 Pump the handle until the resistance felt becomes significant or the dies bottom out. Step 4 Open the release valve by rotating to the left (counter-clockwise). Your termination is now complete. TRUE-HEX Crimp TEMCo TRUE-HEX Crimp Forming Dies apply uniform pressure on all sides for even compression. Leading competitors flattened hex profile attempts to compensate for poor die to terminal fit. This under crimps and often leaves sharp “wings.” Standard Sizing TEMCo dies are sized to USA market industrial standards. Leading competitor dies utilize an estimated metric conversion, leading to incorrect sizing. Marked Terminal TEMCo Dies imprint the AWG on your terminal for inspector proof of correct application. Leading competitor dies will imprint either the non-standardized metric size or often nothing at all. 32 Die Sets Included half sizes (indicated by +) allow for fine adjustments to the size of your crimp. Dies imprint the size into the crimped terminal for code compliance inspections. 16 Standard size dies conform to DIN industrial standards and are compatible with all US domestic market terminals, including color coded lugs. Gauges: STANDARD SIZES: 10, 8, 6, 4, 2, 1, 1/0, 2/0, 3/0, 4/0, 250 MCM, 300 MCM, 350 MCM, 400 MCM, 500 MCM, 600 MCM HALF SIZES: 10+, 8+, 6+, 4