Car Gauge Pro (OBD2 + Enhance) analisi dell'app per 3 maggio

Car Gauge Pro is a complete OBD2 Generic package for all of the OBD2 compliant vehicles. It is equipped with Enhanced Diagnostic Data for your GM, Ford, Toyota, KIA and Nissan. This app is specialized for Ford and Nissan which is fully equipped with Enhanced Data and Active Test just like the factory scan tool! The app will communicate with the vehicle computers at the 16 Pin OBD2 diagnostic connector located under the steering wheel compartment. Elm 327 or STN Bluetooth device is required to make this app work. Car Diagnostic Pro not only can be exciting with Dashboards, it is a Professional Scan Tool. Do you have a check engine light on? Do you want to know the Readiness Status will pass for a Smog Inspection? Do you want to check the functionality of the sensors and determine the status of the Mode 5/6 Emission On-board Test? Car Diagnostic Pro will show you. [OBD2 Functions] All of the Vehicles ✮ Mode 1 - Data Parameters with 220 PIDS ✮ Mode 2 - Freeze Frame Data ✮ Mode 3 - Check Current Faults ✮ Mode 4 - Clear Faults ✮ Mode 5 - O2 Sensor Test Result ✮ Mode 6 - Emission On-board Test Result ✮ Mode 7 - Check Pending Faults ✮ Mode 8 - Enable Evap Test ✮ Mode 9 - Vin, ECU Name, Performance Tracking Data, CALID & etc ✮ Mode A - Check Stored Faults [Enhanced Functions] ✮ Ford (1996-2013) - Check/Clear Faults, Self Test, KOEO, KOER, and Enhanced Data 2200 PIDS (ISO, PWM, CAN) ✮ Nissan (2001-2007) - Check/Clear Faults, Self Test, Ignition Timing Adjustment, Idle Rpm Adjustment, Active Test and Enhanced Data 634 PIDS (KWP2000 - ECM, TCM, ABS, BCM) ✮ GM (1996-2007) - Check/Clear Faults, Active Test and Enhanced Data 189 PIDS (VPW Powertrain) ✮ Toyota (2000-2006) - Enhanced Data 150 PIDS (ISO - Powertrain) + Read/Clear Faults (KWP2000 Airbag) ✮ KIA (1996-TBD) - Enhanced Data (ISO Powertrain) ✮ Enhanced Functions may not support some models Please Note: Some of the Bluetooth Devices are not compatible with the app. App does not support the Mini Elm 327 v2.1! Hardware Requirement: Elm 327 or STN (OBDLink) Bluetooth Adapter. Vendors: CHX, OBDII, BAFX and OBDLink MX tested OK. Attention Customers: Old Car Gauge Pro cannot be updated due to keystore file required for an update is missing.