Top 10 mectronica.it Competitors

temera.it

We give "digital voice" to the products and help companies overcome their most competitive challenges and successfully meet all their customer expectations.

shopnfc.com

Cartes NFC en PVC, avec puce NXP MIFARE® DESFire® EV3, avec prise en charge du cryptage AES, message SUN, EAL5+ et 1 million de cycles de lecture/écriture.

ampio.com

Home automation at the highest level.

smartnydom.pl

Strona 2 | Witam, pół roku temu pytałem o sterownik rolet i trochę się już zmieniło. Zrobiłem tak że mogę mieć włącznik do rolet obok okna czyli taki ...

imou.jp

Wi-FIカメラ、ライブを楽しもう！

tagstand.com

Android app Apple COVID-19 data iPhone Mac NFC nfc reader solution stickers Tappy TapTrack writer

smarthomeintegrations.co.za

Included with the firmware is support to help you get up and running. By purchasing this firmware you are contributing to the future development and support of this firmware. This firmware enables your inverter to be controlled by home assistant and reports real-time data. It plugs into a dashboard that can be loaded for free at  https://github.com/tomatensaus/DeyeSolarDesktop/   (follow youtube link for instructions) Hybrid Inverters from Deye/Sunsunk/Sol-Ark/Magneto/Noark and other official re-brands (using the Deye design) are all fully supported. It supports 3.6/5/6/8/10/12/14/15/16/18/20 kW Single phase and Split Phase. 3Phase 6/8/10/12 kW Supported 3Phase 8/10/12/20/30/50kW High Voltage Supported American Standard Split/Bi-Phase Supported Master/Slave is currently supported by 2 separate dongles (and 2 sets of firmware). Steps: First flash your microcontroller with the Inverter demo software available on the site and see if it works. Be sure the use the port meant for BMS comms (BMS485/CAN485). Not to be confused with the meter RS485 port Then purchase the firmware and request your inverter serial number be registered for updates. Please note this is still a manual process for now (via email), we are working towards automating this. Check for updates will report "Available" then proceed to click upgrade. Upgrade process takes about 1 minute after which it will reboot and have a new identity. You will receive an email with the decryption password to register with Home Assistant   This firmware is only compatible with ESP32 and requires tx_pin: GPIO17   and  rx_pin: GPIO16, with auto-negotiation. Firmware is copyrighted and you are purchasing a licence for a specific inverter serial number. No unauthorised duplication and reverse engineering is allowed. https://youtu.be/1PDxWjiit5s?si=gJpWmIIlF0IPHYZL

diysmartmatter.com

M4 Mac miniに内蔵できる互換SSDモジュールを買って、miniのSSDを2TBに拡張しました。購入時に2TBオプションを選ぶと、差額が12万円かかるところが、3万円程度で拡張できました。問題なく動作しています。Mac mini用互...

grenton.pl

Potrzebujesz pomocy? Przydatne kontakty, numery i adresy e-mail do działu: wsparcia, sprzedaży oraz centrali.

zuidwijk.com

Passionate about pcb-design, electronics and domotica