The BackOFF™ Brake Light Module automatically flashes your brake light(s) to capture the attention of following drivers and to make your motorcycle more visible. When installed, the motorcycle's brake light becomes significantly more noticeable because your brake light(s) modulates three short flashes followed by one steady-on pulse for four seconds. This pattern automatically repeats itself as long as the brakes are applied. Note: This module will not work with LED brake lights. The BackOFF™ XP Brake Light Module with work with both standard incandescent and LED brake lights. Flash Pattern When you apply your brakes, it causes your brake light to automatically emit a visual alerting signal of 3 short light flashes, followed by 1 steady on light for 2 seconds. This signal automatically repeats itself as long as the brakes are applied. This pattern is not random, but has been selected because of its ability to gain and retain following driver's attention. Most states drivers handbooks recommend that you flash your brakes when slowing or stopping. The BackOFF™ automatically facilitates compliance and enhances safety. Install the BackOFF™ and see how much more effective your brake light can be. Installation To install, wire the BackOFF™ Brake Light Module in-line with your existing brake light wire. Locate your brake light wire and cut the wire into 2 (use a test light or multi-meter to find proper wire). Connect the red wire from the BackOFF™ Brake Light Module to the cut wire end leading toward the front of the motorcycle. Next connect the white wire with the red stripe to the cut wire leading toward the rear of the bike. Finally peel the paper lining off of the double sided adhesive pad and mount the module to a clean, flat surface. Wiring Solder connections or use crimp connectors (not included) Red Wire: Brake Light Wire Leading toward front of Bike White Wire with Red Stripe: Brake Light Wire Leading toward Bulb Specifications Part Number: 01001 Weight: Les