Handler Mfg Market Share Analysis for August 2026

First refer to the instruction manual for guidance. If this is a bigger floor model that is hard wired to a power source (electric or gas), contact your licensed professional for advice and possible service. If this is a bench top model that is plugged into a wall outlet, then check the power source. Make sure all connections are secure. If the device still does not turn on, check for a fuse, and replace it if need be. Also, you can check the on/off switch for any lose terminals or possible failure. You should consult with a licensed electrician. A primary reason for denture processing equipment failure is a lack of proper cleaning and maintenance. In many cases the submersible copper or stainless-steel heating elements are not cleaned or maintained and therefore debris builds up over time causing these parts to fail. If this happens, you can try to clean the unit with non-abrasive cleaners. You may have to have the parts replaced by a professional.