Top 10 seas.no Competitors

repairyourspeakers.com

reparatie van uw luidsprekers, met 30 door audiofriends zelf ontworpen, originele, en andere foam en rubber randen. met 40 video's om u te helpen etc.

madisoundspeakerstore.com

Scan-Speak 4.5" Illuminator Midrange 12MU/4731T-00- 120mm- 4 ohm   Low Q for relatively deep midrange response. The Illuminator woofers are in every aspect unusual designs with the open construction, the extremely long linear excursion and patented under-hung SD-3 (Symmetrical Drive) neodymium motor system, which due to copper caps and its construction ensures very low distortion, adding the unique patented cones, low-loss linear suspension the result is: ”The Very Best Money Can Buy”! The Illuminator woofers are based on compact under-hung motor systems with large neodymium ring magnets. The patent pending motor offers a very long linear excursion together with a very high force factor. The top plate is shaped to “guide” the backside airflow around the motor and with the very open cast aluminum chassis design the driver is virtually free from compression. The under-hung voice coil is precision wound with CCAW ribbon wire on a titanium bobbin for a low loss yet high power handling design. The vented pole piece has contoured openings to eliminate any hint of turbulence noise. The uniquely shaped top plate and open air frame ensure there is virtually no dynamic compression caused by restriction of the diaphragm back wave. Neodymium magnet Under hung motor system One piece cone and dust cap, full cone technology Very Wide Frequency Response 100-10KHz Patented Symmetrical Drive (SD-3) Low-loss Linear Suspension Foam surround High Output 90dB @ 2,83V Madisound recommends: a 2 liter sealed enclosure, loosely filled with wool or acousta-stuf. Your F3 in this enclosure is 185 to 200Hz, depending on the amount of stuffing.

nonsolospeakers.com

Nonsolospeakers instruments for music reproduction

lautsprecher-technik.com

Speaker Surround adhesive is white when applied and then dries transparent. Drying time 15-20 min.   Product Specifications Features Waterproof Content 20g Material Suitability Foam, Metal, Rubber, Cloth Suitable For Surround, Spider, Cone, Dust Cap, Gasket Not Suitable For Voice Coil Part Number KL9001 Brand LT

falconacoustics.co.uk

Ceramic Encased Wire Wound Resistors are primarily intended for use in loudspeaker crossovers, but their close tolerance and rugged characteristics lend themselves to many other applications. We have them available in most values in power ratings from 3W to 17W, our primary ranges are 5W and 11W as these give optimum power rating compared to physical size. They are fabricated from a coil of resistance wire, wound about a former, and welded at each end to a cap, to which in turn the tinned copper lead is fixed. The unit is sealed with a ceramic mix into a highly stable preformed ceramic case. Unless otherwise stated resistors are ±10% or closer tolerance. (Most ±5%). For higher powers two equal resistors in parallel give half value at 2x power (safer at 1.75x)

lydkonsept.no

Nettbutikk for selvbygg og HiFi av høy kvalitet

audiomania.co.kr

[PRODUCT_NAME]

burmester.de

Der erste X-AMP wurde seinerzeit von Dieter Burmester eigens entwickelt und kam in der Wandler Verstärkerkombination 870 und dem Vorverstärker 877 erstmals zum Einsatz.

esoteric.jp

pride and mission of esoteric - the joy of the highest level of musical elation