Pipefitter Pro のアプリ分析 9月28日

Pipefitter Pro is the pipe calculator that works out offset, elbow angle and insert length — and draws the fitting while it does it. Pick the job from the menu, type the pipe diameter and the elbow radius on the workshop keypad, and read the answer off a drawing you can mark from: elbow angle, the length of the straight pipe between the two elbows, elbow takeout, arc lengths and caliper dimensions. WHAT IT CALCULATES • BACK TO BACK — two back-to-back elbows, with the angle or the offset unknown • S TYPE — offset, travel, or a fixed 45° • TEE OFFSET — including the branch diameter • CALCULATOR — one elbow cut out of a 90° • 3D — two elbows in space, set from the A, B and C sides of a box • SLIDER, SLIDER S TYPE, SLIDER TEE — drag the angle and watch the offset change as you go DIFFERENT WAYS TO READ A RESULT A result opens on the Angle, Dimensions and Elbow tabs, and on some cases a 3D view you can rotate and zoom as well. The elbow calculator has its own reading modes, and the spatial module has 3D, Alpha 2D and Beta 2D views. Which views you get depends on the case. PIPE AND ELBOW TABLE A built-in NPS/DN table with outside diameter and centerline radius, for long radius and short radius elbows. Add your own sizes and pull them straight into a calculation. BUILT FOR THE BENCH • Millimeters, centimeters or inches • A large numeric keypad instead of the system keyboard • Favorites for the cases you use every day • Works completely offline — no account, no connection, no ads BEFORE YOU CUT Pipefitter Pro supports the preparation of workshop work. Check the dimensions against your technical documentation and your shop procedures before cutting and welding.