11月19日的Magedori: Conduit Bending Calc应用程序分析
Magedori: Conduit Bending Calc
- Daisuke Yamaguchi
- Apple 应用商店
- 付费
- 生产力
Stop hunting through preset lists for your bender.
Make one test bend and the app learns how your bender actually bends. From then on, the numbers match the pipe.
CALIBRATE TO YOUR OWN BENDER
Benders of the same size bend differently with make, age, wear and the hand on the handle. Book values drift. Bend a 90° on a scrap piece, measure it once, and the app works out your real centerline radius for that size and keeps it.
EIGHT BENDS
• 90° stubs and any-angle bends
• Kicked 90°: marks for the 90° and the kick, distance between them, shrink along the run
• Offsets with distance between marks and shrink
• Rolling offsets (new in 1.5): enter the rise and the roll, get the true offset, how far to roll the pipe, and both marks
• 3-point saddles
• 4-point saddles
• Single bends at any angle
• Parallel runs: how far to shift each mark
MARKS FROM THE PIPE END, IN ORDER
Results are a list of distances measured from the end of the pipe: ① bend start ② bend end ③ cut. Lay your tape along it and mark. Choose whether you measure to the back, the center or the inside, and the red line in the drawing moves to show you.
TOLD WHY IT WON'T BEND, AND WHAT WILL
If two arcs would overlap, the app says so, says by how much, and offers an angle that works. One tap switches to it.
EMT, IMC AND RIGID, IN INCHES
All ten trade sizes from 1/2" to 4" for EMT, IMC and RMC, with fractions to 1/16". Metric steel conduit (EN 61386) and Japanese JIS conduit are included too, in millimeters.
NEC RADIUS CHECK
Warns when the centerline radius falls below NEC Chapter 9 Table 2.
BUILT FOR THE JOB SITE
• No sliders. Type numbers on the keypad or tap +/- steps
• Every feature works underground or with no signal
• What you enter never leaves your device. To improve the app, only anonymous usage data (such as which screens are opened) is counted with Google Analytics (you can turn this off in Settings).
• No ads, no in-app purchases. One-time purchase, everything included
• Save calculations to history
Results are a guide. Final dimensions and code compliance are the responsibility of qualified personnel following local rules and your AHJ.
Requires iOS 17 or later. iPhone and iPad.
商店排名
商店排名基于 Google 和 Apple 设置的多个参数。
所有品类在
美国--
生产力在
美国--
创建账号以查看平均每月下载量联系我们
动态Magedori: Conduit Bending Calc排名统计
Magedori: Conduit Bending Calc的 Similarweb 使用排名和Apple 应用商店排名
排名
没有可用的数据
十一月 19, 2026
