Les 10 concurrents hytekgb.com les plus visités

fueldump.co.uk

Shop our full range of products at FuelDump, including Oil Heating Equipment, Refuelling & Liquid Transfer and AdBlue / DEF Equipment.

commercialfuelsolutions.co.uk

The Cim-Tek tank dryer is a unique product which enables you to absorb water from your fuel tank without the need to install filters or conduct an expensive pump out. The Cim-Tek tank dryer is suitable for both single-skin and bunded tanks. Each unit absorbs up to 440ml of water from the tank before becoming full and begins to work as soon as it is placed in the tank. Simply lower one or more tank dryers into the fuel storage tank through either the fill point, vent or inspection hatch and then tie them off using the supplied oil-resistant cord. Once placed in the tank the absorbent sock will begin to work straight away and within one hour is ready to be checked. After a week the tank dryer should be removed from the tank, it is easy to pass the swollen sock back through the fill point even when full. Water can be found in fuel tanks through a variety of sources, mostly caused by condensation on the inner tank wall which coalesces and settles at the bottom of the tank over time. Rain and even melting snow which enters the tank through the vent (or open lid) can also contribute to the amount of water collected. Suitable for both plastic and steel fuel tanks. Available to purchase either singly or at a discounted rate in a pack of 12 units.

oilybits.com

4 Litre Closed Circuit Aviation Fuel Sampler 'CCS' Visijar Full visual aviation fuel checking in a closed system No fuel spillage Easy detection of dirt and water No sample contamination Easy to clean Direct drainage under gravity Water Detection, Density, and Temperature Checking Options NEW Feature 2026> Ability to mount as left hand or right hand entry NEW Feature 2026> Optional Secondary Chamber with 2 tubes for Thermometer and Hydrometer, replacing previous internal tubes. NEW Feature 2026> Optional mounting bracket available for retro-fit with previous design and to fit to support stand. NEW Feature 2026> Optional Offshore Paint (White) Introduction The accepted method of checking the cleanliness of aviation fuel is the 'clear and bright' test, where fuel is swirled around in an open bucket or clear glass jar and visually inspected. However this procedure carries the risk of sample contamination from the elements or from dirty sample points. There is also a high probability of fuel spillage and contact with operations staff. The Closed circuit Sampler 'CCS' has been developed to overcome these problems and actually improives sampling procedures, and as a result it is in widespread use with refueling companies all over the world. JIG Bulletin 123 & JIG TID No 3 detail the design, use, and maintenance of the CCS. With this in mind, the manufacturer has developed this 2026> updated version to assist with visual appearance checks. Description and Operation The CCS consists of a clear glass tube fitted with a white epoxy coated conical base to assist in the detection of dirt and water, sediment and suspended matter. The CCS is fitted with a hinged cover that fully opens to allow for easy cleaning. The base incorporates a tangential inlet port to promote vortexing of the incoming fuel, and a close coupled stainless steel drain valve. The inlet port should be connected to the sample points using small bore tubing (typically 10mm diameter), and we recommend fitti

bellflowsystems.co.uk

Max Flow rate 200 kg/min (20:1 Turndown)Liquid Accuracy +/- 0.1% (See options)Gas Accuracy +/- 0.5%Repeatability +/- 0.05%Tube Material 316 Stainless Steel40 Bar Max W.P (Subject to connections)DN25 Flanges PN40 (See options)Process Temp -70 to 160 Deg. C (See Options)Remote Display 24V DC or 85~265V AC, 50/60 HzAtmospheric Temp -30 to 60 Deg. CIP67 Ingress Protection RatedCable Length 5m (See options)4-20mA, pulse ,Modbus RTU RS485 (HART optional)ATEX (Flow Sensor) - II 2G Ex db IIC T6...T1 Gb ATEX (Transmitter) - II 2G Ex db [ib] IIC T6...T1 Gb

rpm-fuels.co.uk

rpm fuels & tanks stocks bunded diesel fuel storage tanks, domestic heating oil tanks, transfer pumps & more in a range of quality brands.

centretank.com

Looking for a trusted supplier and stockist of fuel dispensing, tank and AdBlue equipment? We at CTS have 35 years experience doing exactly that.

gpi.net

We’ve been building superior products since 1972 in the heart of the Midwest – Wichita, Kansas, USA. We are home to GPI®, GPRO®, and FLOMEC® brands, dedicated to providing our customers with the most reliable products and superior lifetime performance.

xylemflowcontrol.com

Xylem is a leader in developing innovative water solutions through smart technology. Learn more about Xylem's water, wastewater and energy solutions.

tankservices.co.uk

Portable petrol pumps, also known as mobile or handheld fuel transfer pumps, are compact and convenient devices designed for the efficient and safe transfer of petrol (gasoline) from one container to another. These pumps are widely used in various settings, including automotive maintenance, small-scale fuel distribution, boating, and emergency refuelling situations, where access to traditional petrol stations may be limited.